Cat5e, Cat6, Cat6A or Fiber: Choosing Cable for Security Networks

Cable is the cheapest line in the BOM and the most expensive to change later. The choice comes down to four questions: how far, how much bandwidth, how much PoE current, and what the environment does to the jacket. Answer those and the category picks itself.

1. What each category actually supports

Cable	Rated speed	Max channel	PoE suitability	Typical use here
Cat5e	1G	100 m	adequate for af / at	indoor camera drops, short cabinets
Cat6	1G to 100 m, 10G to ~55 m	100 m	better heat and loss behaviour	default for new camera projects
Cat6A	10G to 100 m	100 m	best, heavier and stiffer	10G uplinks, dense PoE cabinets
Fiber (OS2 / OM3-4)	10G+ to km	km	not applicable	building-to-building, runs over 100 m

Cat5e is not obsolete for cameras — 4MP H.265 streams fit easily in 1G. What Cat5e loses is margin: on a 100 m PoE run at 30 W it dissipates more heat in the bundle and has less headroom for a poorly terminated connector. On new installations Cat6 costs little more and removes both worries.

2. CCA is the failure nobody budgeted for

Copper-clad aluminium looks like copper, tests like copper on a continuity checker, and fails on PoE. Aluminium has roughly 60% more resistance, so the same run drops more voltage and heats more. Cameras brown out at night, PTZs reboot when they pan, and the installer blames the switch.

Insist on solid copper (bare copper or copper-clad steel is a different, valid product — CCA is not).
Cut a strand and look: aluminium is white and snaps, copper is copper-coloured.
Check the reel print — "CCA", "copper clad" or a suspiciously light reel are the tells.
On long PoE runs, CCA can lose several volts; that is the difference between a working camera and a reboot loop.

3. When copper stops being the answer

100 m is a hard channel limit, not a guideline, and it includes patch panels and bends in the path. Beyond that — or between buildings, where earth potential differs — fiber is the correct engineering answer, not an upgrade.

Between buildings: fiber removes both the distance problem and the surge path.
Over 100 m within a site: fiber or a PoE extender, never a longer copper run.
Very noisy electrical environments: fiber is immune, copper is not.
In practice: an optical converter at each end turns a long copper run into a fiber link without changing the camera side.

For a run that is long but not building-to-building, our note on long camera runs compares extenders and converters in more detail.

4. Jacket, environment and the details that bite

Outdoor: UV-rated or flooded gel cable, and a drip loop at every entry point.
Plenum spaces: CMP-rated jacket; it is a code requirement, not a preference.
Trays and conduits: fill ratio under 40% so PoE heat has somewhere to go.
Cabinets: bundle PoE runs loosely — dense bundles of 30 W runs get warm.

5. The short version

Situation	Cable
Indoor camera drop, under 60 m, af/at	Cat5e solid copper is fine; Cat6 preferred
New build, any PoE, up to 100 m	Cat6 solid copper
10G uplink or dense PoE cabinet	Cat6A
Over 100 m, or building to building	Fiber with converters or SFP uplinks
Anywhere a cheap reel is tempting	check for CCA before it goes in

Send the run lengths and camera models and we will confirm which port standard and uplink you need at each cabinet. Ask for a quote.

FAQ

Can I run PoE over Cat5e?

Yes. Cat5e carries 802.3af and 802.3at fine within 100 m. It has less thermal and voltage headroom than Cat6, so it is a poor choice for long 30 W runs or dense cabinets.

How do I tell CCA from copper cable?

Cut a single strand. Copper is copper-coloured and bends; aluminium is white, lighter and snaps. Reel labels also state CCA or copper clad — treat those as a rejection.

Is fiber better than copper for cameras?

Only when distance or electrical isolation demands it. Fiber carries no power, so cameras still need local power or a PoE switch at the far end.

Does Cat6 improve camera image quality?

No. Cable does not change image quality. It changes error rates, voltage drop and the reliability of the link — which is what makes a camera look unreliable.

As especificações técnicas detalhadas são fornecidas em inglês.

← Recursos